There is also a notch at the top of the left bodice 3/4″ (2 cm) from the edge. Right back facing (as worn) has ZERO seam allowance.Left back facing (as worn) has ZERO seam allowance.Right bodice (as worn) of the zipper seam allowance is 1/2″ (1.25 cm).Left bodice (as worn) of the zipper seam allowance is 3/4″ (2 cm).You will need to add or subtract seam allowances as such: If you are not using my pattern, there are certain things you need to pay attention to. I am saying “part” because, for clarity’s sake, I cut it very short and narrow, so I don’t have to worry about capturing the long zipper in the photo frame. I am using part of my pattern, the Beausoleil Top & Dress, for this demonstration. The bonus is that there’s no hand stitching! It might look a bit strange to you (actually, in concept, it’s quite similar to the invisible zipper installation I posted earlier), but it offers a nice finish inside too. This technique is used on ready-to-wear clothing. I don’t think it’s immediately obvious how the facings should be handled. ![]() However, most of them don’t tell you how to finish it with a facing (or lining). ![]() Many tutorials out there go over the installation of the lapped zippers using different techniques, which are fine and dandy. Today I want to go over how to install a lapped zipper with facings. How to Install a Lapped Zipper with FacingsĮven though my favorite zipper is the invisible zipper, occasionally, I’d venture into other types of zippers for different looks.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |